3 Horsepower Motor Reviews

To quickly get yourself a product from area to another, most facilities use conveyors. Conveyors are observed in many factories that use the assembly line strategy to assemble products. However, conveyors have many uses and therefore are not merely restricted to a assembly line production facility. Pallet conveyors, also known as palletized transport systems, are used to move pallets derived from of area to another for a variety of purposes and appear in four styles. These styles would be the belt conveyor, roller conveyor, the chain conveyor and the cam driven.

Roller And Chain Conveyors

All four styles hold the ability to maneuver heavily loaded pallets without much difficulty. However, essentially the most common styles that are employed will be the roller and also the chain. Some may even work with a combination from the roller and the chain conveyors. For that reason, those will likely be the 2 that people will discuss.

Roller and chain styles can be assembled to a specification that is certainly needed. The more standard sizes however they are with all the width ranging from a few inches to 12 ft and length including 5 ft and 8 ft. Although it really is not rare to see either of those conveyors reaching a length up to 40 ft. The pallet conveyors are made with a common width sized 36 inches to 60" to accommodate the common pallet sizes.

Product Specifications

4-gauge steel channels are employed to the frames for types of conveyors. For the roller conveyors the rollers are made out of 11 gauge steel and are usually 2 1/2 in diameter. The speeds will even vary with typical speeds being from 30 to 60 feet per second. For the ones that want it, a speed of 150 feet per second can be obtained.

The spacing between the rollers range from 3 inches to 12 inches. For the chain conveyor sizes run from RC 40, 50, 60 or 80. The 80 size could be the heaviest duty of the chain conveyors. The drive of the chains comes from 1/4 HP to 5 HP. The horsepower motors are normally 3 phases but a single-phase motor could be acquired.

Combination Conveyors

For the ones that work with a mix of roller and chain conveyors a cross transfer is used. This cross transfer will move the pallet 90 degrees derived in one of style of conveyor for the next, either starting over a roller and ending on the chain or starting on a chain and ending on a roller. Either way the cross transfer works the identical way only in reverse. If moving through the rollers to chain the chain section will be lowered and when moving from chain to roller the chain section will probably be raised.

To maintain the roller and chain pallet conveyors moving smoothly they have to be lubricated. The downside with this is that buildup can occur. Buildup may cause the conveyor to fail to go the pallets as smoothly as possible. To decrease on buildup, they should be cleaned regularly and new lubricant placed on them. This can reduce into productivity and so ought to be preformed routinely.